Содержание
The bin
«object format» does not produce object files: the output file
produced contains only the section data; no headers or relocations are generated. The
output can be considered «plain
binary», and is useful for operating system and boot loader development,
generating MS-DOS .COM
executables and .SYS
device drivers,
and creating images for embedded target environments (e.g. Flash ROM).
The bin
object format supports an unlimited number of
named sections. See Раздел 6.2 for details. The
only restriction on these sections is that their storage locations in the output file
cannot overlap.
When used with the x86 architecture, the bin
object
format starts Yasm in 16-bit mode. In order to write native 32-bit or 64-bit code, an
explicit BITS 32
or BITS 64
directive is required respectively.
bin
produces an output file with no extension by default;
it simply strips the extension from the input file name. Thus the default output filename
for the input file foo.asm
is simply foo
.
bin
provides the
ORG
directive in NASM syntax to allow setting of the memory address at
which the output file is initially loaded. The ORG
directive
may only be used once (as the output file can only be initially loaded into a single
location). If ORG
is not specified, ORG 0
is used by default.
This makes the operation of NASM-syntax ORG
very
different from the operation of ORG
in other assemblers,
which typically simply move the assembly location to the value given. bin
provides a more powerful alternative in the form of extensions to
the SECTION
directive; see Раздел 6.2 for details.
When combined with multiple sections, ORG
also has the
effect of defaulting the LMA of the first section to the ORG
value to make the output file as small as possible. If this is not the desired behavior,
explicitly specify a LMA for all sections via either START
or FOLLOWS
qualifiers in the SECTION
directive.